Emergency brakes have been originally designed to stop a vehicle in movement during an emergency. Modern braking systems have made this use largely obsolete, and emergency brakes are actually used primarily as a parking brake. Ford F-sequence vans have been in continuous production since 1948, with an abundance of assorted makes and models, so it is a very general guide to putting in emergency brakes in a Ford truck. For particular procedures, seek the advice of the proprietor’s handbook for your explicit truck.
Ford Truck emergency brake Installation Instructions
1. Park the truck over a hoist. Place the transmission in neutral gear and release the parking brake. Take away any panels essential to entry the parking brake, and raise the truck with the hoist.
2. Pull the parking brake cable to its most limit of travel, and insert a retainer pin the place acceptable to prevent the cable from retracting. The parking brake should have no rigidity on it. You may probably want an assistant to hold the cable whilst you insert the retaining pin.
3. Use a socket wrench to disconnect the parking brake cable. Remove the rear brake discs and the front brake discs, depending on your explicit vehicle.
4. Unfasten any brake shoe adjuster screws that attach the brake springs, using a screwdriver. Remove any brake springs and pins on the parking brake footwear, and remove the parking brake shoes.
5. Lubricate the brand new footwear for the parking brake on the points the place they’ll contact the damage pad. Install the new brake shoes and ensure they’re centered with respect to the brake pads.
6. Fasten the springs, pins and screws for the brake footwear, and join the parking brake cable. Use a torque wrench to tighten the screws to the correct torque. Take away the retaining pin on the brake cable, and regulate the clearance on the parking brake as acceptable on your vehicle.
